Tools And Assembly Items: Pen Drill Guide And Trim Kit

Drill accurate 7mm, 8mm, 3/8" or 10mm holes in your pen blanks using ONLY a hand drill. This hardended metal guide includes built in bushings for the 4 most popular hole sizes for pen tubes. No special drill press jigs or fixtures are necessary.

Here's a complete barrel trimming system. An essential step for making a quality pen project is to square the end of your pen blanks and pen tubes prior to final assembly.

PSI's system includes cutting shafts that will fit into a drill chuck or lathe chuck. The shaft will clean the glue from the tubes and act as a pilot for the 3/4" squaring cutter. This complete system includes:

*7mm, 8mm, 3/8", 10mmpilot shafts

*3/4" squaring cutter, allen wrench & instructions

*Sleeve adapter for PKPARK-PCL &PKMONT-PCL kits

Only 1/16" wide! Get a clean, sharp and accurate 90 degree angled corner for delicate turnings. Ideal for cutting tenons for pen center bands.  Blade is 1-1/4" wide x 1-7/8" long. Overall size is 9". Made in China.

Measure and maintain the proper wall thickness of your bowl. Transfer your bowl's wall thickness measurement to outside caliper tips withour removing it from your work. An 8" from pivot to tips.

Thickness calipers display actual measurements from 0 to 2 inches. Measurements are taken in 1/32 inch increments.

Set of steel calipers and dividers for the accurate measurement of bowls or use them for baseball bats or any other project requiring precise measurements.

Available in #1MT and #2MT sizes, you will save over $60.00 with this quality accessory set! Individual items purchased seperately elsewhere would cost over $100!! This set includes hard to find replacement centers for all lathes equipped with #1 and #2 MT headstock and tailstock centers.
  INCLUDES: 5/8" dia. headstock spurcenter for narrow spindles, 1" dia headstock spur center for standard spindles, Live ball bearing tailstock center w/cup and point, and hollow center for drilling 5/16" (#2MT) through holes (for lamps,etc) & 3/16" (#1MT)

Available in #1MT and #2MT sizes, This multi-tooth live tailstock center provides a great grip with less stress and avoids splitting your wood. It has sealed bearings and spring loaded point for easy positioning and wood removal

Available in #1MT and #2MT sizes, Large & heavy duty with 60 degree point and ball bearing precision.

Available in #1MT and #2MT sizes, Large & heavy duty with 60 degree point and ball bearing precision.

Available in #1MT and #2MT sizes, Get a better bite on your spindle with PSI's 'Super Center'. More teeth give you a better bite while providing equal pressure and a positive drive. There is no need to hammer your drive center into the work piece and risk splitting work. A spring-loaded point simplifies the positioning of your spindle in the center and retracts to avoid splitting yoru work when tailstock pressure is applied.